The Tuul Crib 7,332 #1 Posted October 21, 2018 What is the best way to remove these bearings from the spindle hubs? I took the retainer ring out of one and do I just pound them out from the other end? Share this post Link to post Share on other sites
daveoman1966 3,586 #2 Posted October 21, 2018 (edited) Kinda.... There is a bushing inside the spindle. Use a long 3/8 extension bar to 'cock' that bushing sideways...as much as you can....then tap the ext bar with a hammer, with the end of it just catching the edge of the bearing...on the end where you removed the clip... Do this from side to side, until the bearing drops out. It is a greasy mess. Edited October 21, 2018 by daveoman1966 Share this post Link to post Share on other sites
