Jump to content
Bobbi Barroso

Transmission fluid

Recommended Posts

Bobbi Barroso

I accidentally added a 1/2 quart of SAE 30 in the transmission, is it ok or do I need to drain it out?

Share this post


Link to post
Share on other sites
 
pfrederi

 What model tractor....Hydro or gear drive transmission??  if it is a gear drive the 1/2 qt won't hurt anything.  They used to use 40w motor oil in them

Share this post


Link to post
Share on other sites
 
Bobbi Barroso

Model 310-8, gear drive.  This tractor was given to me and I know nothing about wheelhorses!

Share this post


Link to post
Share on other sites
 
gwest_ca

Welcome to the forum.

Do you know your model number? Good chance we have the appropriate operator manual and more to bring you up to speed.

 

Garry

Share this post


Link to post
Share on other sites
 
pfrederi

The model number may be on a sticker on the rear fender under the edge of the seat

Share this post


Link to post
Share on other sites
 
WVHillbilly520H
3 hours ago, Bobbi Barroso said:

Model 310-8, gear drive.  This tractor was given to me and I know nothing about wheelhorses!

Being gear drive it would take any good gear lube in the 80/90wt range but 30w won't hurt it

  • Like 1

Share this post


Link to post
Share on other sites
 
KC9KAS

@Bobbi Barroso :text-welcomeconfetti: to :rs:.

Our manuals section has a LOT of manuals!

Share this post


Link to post
Share on other sites
 
Bobbi Barroso

  I D #2110K806.     37701

Share this post


Link to post
Share on other sites
 
pfrederi

1985 Model here are some manuals

 

 

 

An operator manual for a 1986 should be very close.

 

 

Share this post


Link to post
Share on other sites
 
gwest_ca

Should be a 1989 model. Click on the picture

Garry

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Similar Content

    • OHLB
      By OHLB
      Newbie here. 310-8 won't start. Battery is dated 10/19. Did crank a couple times but started losing ummph. Should I replace it or attempt to charge it? Can't tell if the battery is frozen. Never knew until today that batteries could freeze and that it's dangerous to charge a frozen battery. It's been single digits with wind chill the last couple weeks here. 
    • Big Rig
      By Big Rig
      ISO clutch neutral safety switch for 310-8
      or alternative 
    • Rob R
      By Rob R
      Soo couple of years back did a pulley change on the tranny from 6 inch to 4.5 and used a 1/2 X 79 belt to make it work and it worked fairly well but wanted to get back to a 5/8 drive belt so went to a 5/8 x 81 inch belt and added a second flat Idler pulley. I simply cannot believe how smooth and sharp it shifts and drives now!  The added flat Idler was 2 3/4" with a 5/8ths bore used and existing hole on the side shroud and just opened it up a bit. I use to slip a bit on steep hill with the 79" slips no more, the belt drives and the clutch is  LOT smoother and in the right pedal area.... Will see how it holds up cut 3/4 of an acre of grass yesterday NO issues. 





    • Ifixoldjunk
      By Ifixoldjunk
      So I was out mowing the other day with my 310-8 and somehow snagged my wheel in a hole in the yard. Anyways I pretty much destroyed my ball joints. I've since replaced the tie rod with junkyard parts but I was wondering if anyone's found a heavy duty aftermarket replacement for the tie rod assembly.
       
      Like would generic adjustable go-kart tie rods do the trick?
    • Ifixoldjunk
      By Ifixoldjunk
      so I spent a few hours today welding up a custom front weight bracket for my 310-8. It has two and a half inches of ground clearance with a generic 12 inch weight bolted on. 
       
      so the question is, how well do y’all think the 300 series front axle will hold the weight? It’s only 50lbs so it’s lighter than the snowblower it has to hold up in winter so I don’t think I’ll have any problems. And I really don’t intend on using it constantly.
×
×
  • Create New...