Jump to content
  • ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Similar Content

    • By Canaaner
      Ran fine all summer, no blows the dash fuse (10 A) once it's started. Will run momentarily then, fuse blows and nothing. Replaced fuse, ran for a minute then fuse blew again. Any help?
    • By The Tool Crib
      Anyone have a wiring diagram for a 655. I found one but I'm not sure if it's correct on the hook ups any help would be appreciated!
    • By Sirtowsalot
      Howdy y'all!
      I'm having some trouble with my 418-A. I think it is ignition related, but I'm not completely sure. It starts and runs perfectly fine, but when I go to turn it off, it doesn't work. I can just turn the key into the 'off' position and take the key out while the tractor is still running and it will continue to run as if I hadn't turned the key off.
       
      I'm trying to keep this tractor as original as possible, so I don't really want to buy a new ignition. Any help is appreciated. Thanks!
       
      *EDIT*
      Wheel Horse 418-A
      Kohler Engine
      18 HP
      Model No. M18QS
      Spec. No. 24510
      Serial No. 1619706606
    • By Amoootray
      I have a 552 with a 5.5 hp Tecumseh that has was running then one day would not start cause it had no spark . I cleaned the points put it back together and still have no spark. Looking for magneto parts and having trouble finding parts wonder if anyone could help me locate one .
    • By RJ Hamner
      Let me first say that it ran when I brought it home.  Drove it around the guys yard, tried out the mower, drove it onto the trailer and drove it off the trailer and into the garage.
      I've done a "ground up" restore on the tractor (70 Charger 12).  Swapped out the breakerless for a battery ignition and swapped out the 10 amp for a 15 amp stator, flywheel and regulator.
      Pulled the head, looked pretty good, new head gasket and head bolts.new fuel pump, fuel lines,new switches and wiring, new aftermarket carb, new coil, coil wire, new points, new throttle and choke cables.
      Static timed (twice just to make sure) Have tried Autolite 216's and the hotter 437's. changed the condenser to the high dollar Kohler one.
      It will idle but when I give it some throttle it stumbles or will rev up a little then quits.
      I've gone thru the "trouble shooting " steps multiple time and to no avail
      Anyone got any ideas??  I am willing to try most anything at this point
       
      Bob
×