Jump to content
JAinVA

Cooling fins

Recommended Posts

JAinVA

I just got a K321 engine in the shop today.The engine lost a rod and it welded aluminum to the crank.The crank had the pto shortened to about

an 1 1/2" so I will replace it anyway.The bore is good enough that a light hone and stock parts will be fine.The bad part is that the top 2 cooling fins

on the pto side away from the valve side got broken off.I have the pieces so I could silver solder back on.

My question is should I do that or leave it alone.Do anyone of Kohler guys have experience with this issue? I have other undamaged blocks but they all need to be bored.Thanks in advance for your perspective,JAinVA

Edited by JAinVA

Share this post


Link to post
Share on other sites
 
Ed Kennell

I don't have any practical experience Jim, but my gut is telling me two missing fins will not cause a significant increase in engine temperature..

Having said that, If you have the equipment to solder the aluminum, do it, if nothing else for cosmetic appearance.  :twocents-mytwocents:

  • Like 1

Share this post


Link to post
Share on other sites
 
JAinVA

The missing cast iron sections are about 2" long. Cooling air blown by the fan are blocked between the 1st and second fins by a cast support section.Were it not for that the top fin would have received more damage.Like you I think it will be fine but it is surely ugly.

Its always something.Thanks,JAinVA

Edited by JAinVA
  • Like 1

Share this post


Link to post
Share on other sites
 
JAinVA

I am going to try JB welds hi-temp bonding agent.It may have some heat transfer issues but at least it won't look so dam# ugly.Other than the fin damage this is a nice block.

I will definitely let the board know the results.I will post some pictures when I can.JAinVA

Edited by JAinVA
  • Like 1

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Similar Content

    • Don66
      By Don66
      I have a 1978 Wheel Horse 8 speed tractor,Kohler 321 engine. I've been working on restoration, finally got the mower deck finished and installed. Before this, the engine was easy to start and ran well. Yesterday it would not start with ignition key, would not even turn over, so I jumped it with a screwdriver between cylinoid and battery. The engine started and ran about 10 seconds and died. Now I get no spark and the engine won't fire off. I checked the wiring and everything seems to be connected and without damage. I don't have test equipment available so I'm stumped at what went wrong. Any suggestions?
    • Rob R
      By Rob R
      I am currently doing a ring, piston, hone rebuild on a K 321 off a Ford LGT 145 Tractor  on this machine they actually welded the rails to the bottom pan (see pics). My intention here is to put this puppy in a red machine (312-8 or GT14). I definitely have the small pan with the expanded bottom for the long dipper.
      Here's my questions:
      > Can I carefully remove the rails from the pan, cutoff the old front axle mounting bracket(s) and then drill holes in  the flanges to mount  to the Wheel Horse rails.
      > Since the engine is side mounted will the expanded bottom fit between the standard Wheel Horse rails?
      > If not possible to make this old pan work what flat pan would work and do I need to get the expanded bottom one (big dipper}
      > any recommendations here would be appreciated don't want to go down to many blind holes here...….
       
      Thanks much!








×
×
  • Create New...