proama 35 #226 Posted October 16, 2018 I wish I was steves neighbor ! you rock! I feel like I know this transmission personally ! this will be a big help as I am trying to get hubs off to rebuild my transmission on my 401 suburban 2 Share this post Link to post Share on other sites
Tractorhead 8,571 #227 Posted October 16, 2018 Hi, read the whole Story. my deepest Respect to all who are involved. Fantastic work at all, no doubt about it. About E- Tank i doing somevtry's in the past, but never tried to remove Rust. very impressive also! Thanks for Sharing all this Info Stefan 1 Share this post Link to post Share on other sites
stevasaurus 22,229 #228 Posted August 11, 2023 Let's see, it is August 11, 2023. I just re-read this whole thread. It brought back a lot of good memories. It still reads well and has a fair amount of humor. I love that we did this thread. 1 Share this post Link to post Share on other sites
TheGrinch 0 #229 Posted August 19, 2023 I just finished one for my friend Tim (VT Tim) thanks to Steve and others info here it was a breeze except for a couple of issues. The pictures of the bearing installation in an early post was wrong and of course I installed the bearings in the wrong places so I ruined them getting them back out with the welder lol. The original early seal style axle tubes are quite a bit longer than the later ones with the outer type axle seal. I replaced his and had to trim them quite a bit, I forget how much. After about 10 beers I got all of the gears in correctly. Ground Bearing R12https://www.mcmaster.com/60355K185/ Un-ground Bearinghttps://www.mcmaster.com/6383K49/ Outer Tube Bushingshttps://www.mcmaster.com/6391K726/ Share this post Link to post Share on other sites