Jump to content
SolarStallion

PTO Help!

Recommended Posts

SolarStallion

HI,

I have a C-120/C-160 that someone mounted a Briggs & Stratton twin 402417 0660 01 81080512 in it. I am looking for a PTO that will fit this. Not sure if it even has the original drive pully. The pully shaft has a key that extends past the pully so the pto sleeve does not go on. How does the pully remove if needed?

I bought a GT Workhorse for parts. The pto on it has a 4 hole mounting to the pully. The pully on this tractor has 3 holes. Any advice?

Thanks.

post-8147-0-04860200-1405002149_thumb.jp

post-8147-0-70855000-1405002165_thumb.jp

Share this post


Link to post
Share on other sites
 
WH nut

You are going to have to strip it down to the bare crank and use the drive pulley and PTO off the GT. They are held in place with set screws. make sure they aren't doubled. You will need a puller to remove then. If you have room use a 3 jaw behind the pulley. If not, I have had good luck with a 2 jaw in the pulley groove.

 

 

Also. make sure the crank size is the same. There is a 1in and a 1 1/8

Edited by WH nut

Share this post


Link to post
Share on other sites
 
woodchuckfarmer

Clean the crank up good with emery paper it will come off a lot better.

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...