tgordonjr 0 #1 Posted November 4, 2009 So I have been in the process of restoring my 211-5 and have finally got it down to frame and motor, so I can sandblast it and paint it. I was trying to get the large pully off of the rear axle by using a dead blow hammer and some man power since i figured after the set screws were out it was just pressed on. well I guessed wrong or used a little to much man power and ripped the pully right off, along with the shaft, gear, and part of the aluminum axle housing. So now there is a nice hole at the top of my axle. Is there another axle that is stronger that will bolt up to the 211-5? I only ask because trying to find parts for the unpopular 211 series is almost impossible. :ychain: Share this post Link to post Share on other sites
baerpath 517 #2 Posted November 4, 2009 I have a 211-5 rear sitting beside the garage. How to get it from here to Reading is the problem If you figure that part out we'll be all set Duane Canajoharie NY Share this post Link to post Share on other sites