Search the Community
Showing results for tags 'k321'.
Found 5 results
-
Does any one know of a reference link to finding the weight of complete Kohler engines, in particular the K321 & K341? If you know of no electronic data about this topic, but have one of these on the bench and complete, could you somehow weigh it for the benefit of group knowledge. (Sneak the bath scales out to the garage if you can). I'd actually like to see a listing of weights for the entire Kohler K series, if anyone can contribute any piece of this puzzle. Regards, Steve
- 20 replies
-
- 1
-
-
- weight of kohler engines
- k321
- (and 1 more)
-
69 Workhorse K321 engine swap
Machineguy posted a topic in Restorations, Modifications, & Customizations
Hello everyone! I finally picked up a Workhorse 700 and I’m doing a restoration with the exception of a Kohler K321 in place of the scavenged Tecumseh. Anyone done a similar swap and had trans issues or breakage problems? This isn’t going to be a puller, just gonna keep a 42” snow blade on it for small snows and use it for light duty towing and putting around. I have the engine sitting around from another repower project and I have access to a large variety of machine tools and fabricating equipment. Any thoughts? -
any problems replacing a K301 with a K321 on a c120 hydro ?
-
I have a 1969 GT 14, 1-7741, which originally had a K321 14 hp engine that gave up the ghost. That was replaced with a K341 16 hp engine. The original rectifier was used when the new K341 was installed and performed fine. I am now in need of a new rectifier because of broken male spade. How can I identify the proper rectifier to match with a Kohler engine (in my case for a K321 or a K341), and what resource can I research to obtain that information? Regards, Steve
-
Looking for any one who can help me locate a crank shaft for a k321. I think the M14 is the the same but not exactly sure. If somebody could point me in the right direction. Thanks
