Spins VERY nicely and is very solid. 

This had a powered bagger on it so there is a double pulley on the right side spindle.

It is a 1995.

If you need a nice mule drive (with correct belt), I have one for sale for an additional $50.

Will fit 23 x 10.5 x 12 tires

PRICE INCLUDES SHIPPING TO THE LOWER 48

I am selling a large package: the running tractor, a refurbished snowblower (48”), parts snowblower, mower deck (60”), tiller (40”), front plow blade (60”), Cat 0 3-Point Hitch with adjustable top link, WH 3-Point tool bar, wheel weights and tire chains.  Also included is an extensive part collection, nearly a second tractor worth.  I will include the original manuals, an original 1976 sales brochure, and repair manuals for the tractor and the engine.  I made electronic copes of all of the above, and stored the paper copies to prevent further wear. This is one of the most complete D-250 tractor/attachment bundles I’ve seen.

Some highlights from the available parts: Frame rails, extra engine, water pump, extra transaxle, extra gears, including worm gears (stored in oil bath), Front wheel set, carburetor, carb rebuild kit, rebuildable original radiator, extra radiator overflow bottle, rebuilt alternator, new voltage regulator (I was planning to change over to an alternator setup from the generator), new in package Renault engine seals, new PTO seals, ignition maintenance parts.  There are also many panels, frame pieces, cables, levers, tubes (lines) and hardware in the collection.

The tractor engine runs smooth.  There are around 1050 original hours on it; It’s a 1976 edition.  Everything works, except the dash lights and the rear lights (disconnected b/c of fender).  I just haven't sorted out the wiring, but it is all there.  Headlights are good and working, as are all of the gears and levers.  The four tires are nearly new Carlisle Multi Trac, with nubs still on them.  The rear tires have been filled (ballasted) with Rim Guard for extra traction.  The hydraulic pump, front PTO clutch and brakes operate but could use a tune up.  I’ve used it for mowing and snowblowing on hills, driveway and around my land. I don’t have an original WH seat.  The snowblower was rebuilt a few years back, and assembled with all new hardware and bearings.  The mower deck gearbox was professionally serviced recently, and has a new set of blades with only a half dozen mows.  The rear fender needs a repair, but all pieces are available.  The plow and tiller are due for restoration.  The Points, Condenser and rotor have all been replaced and tuned in.  The battery is good.  I've rebuilt the carb, replaced the fuel pump and changed out the plugs within the last 30 hours.  The replacement radiator is from a Kawasaki engine; it was installed with new hoses. There are also new custom hydraulic hoses and a new hydraulic lift cylinder.

Here's a video of me mowing, this past summer.

Transporting this haul in one trip will require a pickup truck and a large trailer.  

Will fit D-160's D-180's, D-200's, and 18 Automatics

All joints move freely and all threads move with the exception of the two pictured (the bolts are bent)

I will ship at buyers expense.

If you need more pictures of a particular part please let me know.

I have a good top link and cylinder for additional money if you need them.

If someone wanted the 48” Wheel Horse snowplow I have listed and the chains I would do a “bundle discount”. Asking $80 for the chains 

I’ve bought wider rims, so I’m selling this setup.
They are 1.5 spacers with all the hardware you need to use them. It worked flawlessly. 
My price includes shipping to the lower 48 states. 
Any questions on these, please ask. I will delete the ad when sold.
PayPal friends and family OR Venmo 
 

Update

Buy the pair for 350. I need the room... Hydro has a loose rear left hub, the B80 definitely needs rear wheel bearings and possibly a housing. They both ran when I picked them up, will need carb cleaning and batteries for both.

Both transmissions worked fine and I yard drove them before purchasing. The fleet is too big , these would be great parts tractors or easily brought up to worker status.

100 Hydro with deck. I bought this and a B80 for the Grand kids. It started and ran when I offloaded it,  Needs TLC

and lots of cleaning but looks to be in decent shape for a 45 year old machine. The Grand kids will get my work horses when the time arrives.

I need the space and hate to tarp them out in the weather !!!!  

I also have a B80 4-speed that is a little rougher and needs rear wheel bearings and seals for sure.  

I can help you load it up .

Mike B

The front at 20#'s and fit flush with the outside of the rim.

The rear weights are 28#'s and they sit recessed inside the wheel (see photo).

Open to splitting up the pair.

C-120 8 Speed.

I acquired the tractor as part of a package deal that included a tiller (which I am keeping).The tractor is in very nice shape with tight steering and upgraded LED front headlights and it appears someone recently restored it with new decals. This model has the heavy duty 1 & 1/8" rear axles with 8 pinion differential. This tractor also has the factory rear lift assembly that could be used to lift a tiller or clevis hitch. The engine is a 12hp Kohler K-301. It does not smoke, but it does have a knock at certain RPMS. 

Asking $600

I dropped the price, I’m offering a bargain because I’m tired of moving them.. I’d like to sell them this week! 

79355 48” Dozer is a very low usage snow plow with both floating and down pressure lift links. Hard to find in this condition, no bends, no abuse. 
 

79356 Mid Grader Blade has been used and the face has been repainted. The paint on the blade face doesn’t last long when used.  These are somewhat RARE.. 

I don’t really want to split them up because I only have one 5Xi axle bracket for sale.

(Classic series axle bracket may work but I’m really not sure. I have several of those.) 

Call me at 717-580-4305

Thanks!

Carl

I have for sale a 5kw front pto mount alternator/generator that fits tractors with the tach a matic system. The generator works excellent and makes power and I can send a video of it running and making power mounted on a tractor upon request. The previous owner butched the mounting bracket, so I have done my best to recreate the original as close as possible, and even used WH stew from spare parts to fab new mounting brackets. I have painted the new brackets to match, while the generator remains in original condition. See pictures below. The price is OBO. Feel free to make an offer. I know it isnt totally original but it works excellent and I know these are quite rare. Comes with rebuilt brackets, lift rod for support, and will come with correct belt as well. I am willing to ship it on the buyers dime as well. Don’t hesitate to contact me if you have any questions. 

in the back of a dealer. Only 70 hours

It comes with

Plow

Wheel Weights

Chains

37" deck

48" deck

15% discount on any 2

25% discount on 3 or more 

$25  hood (PENDING)

$25  seat pan( sold )

$15 belt guard

$25 pair of seat springs 

$20 fender bracket (1of 3 pieces) no fuel tank brackets (sold)

$45 trans plate positioned upside down for low rider 

$45 front attach matic and cut off front end

$20 mid attach matic (sold)

$15 seat spring with seat mount (sold)

$65 Suburban 551 front axle with original long spindels EZ to flip for low rider (1/2" pin)

Rims are in good condition, tires have plugs in them and are usable but not in great shape

If you just want the rims, I'll have the tires dismounted so it saves shipping cost.

$80 plus actual shipping

Would deliver up to ~200 miles (which is roughly Sioux City, Des Moines, Kansas City, Wichita, North Platte) for gas money.

Rims and tires are in good condition.

They weigh 100lbs each!!!

Would deliver up to ~200 miles (which is roughly Sioux City, Des Moines, Kansas City, Wichita, North Platte) for gas money.

Rims are very nice with only a few small rusted ares, beads are straight and in great condition.

$125 plus actual shipping.

Deck is solid and spins very nicely.

The small wheel on the rear of the deck is worn badly (can be seen in the picture)

Would deliver up to ~200 miles (which is roughly Sioux City, Des Moines, Kansas City, Wichita, North Platte) for gas money.

This is a nice solid deck, not all beat up.

Happy New Year!!

I bought this tractor about 6 months ago... got it running and sold it to a Vietnam vet that lives by himself and needed a mower for his house. I told him if he needed too or didn't like it that I would buy it back. Well... his furnace quit for the 4rth time in the last month and I bought it back for every penny that he gave me. 

Since I sold it to him he started doing a decent restoration and never got to painting hood. But... it has alot of new "do dads" and parts. It runs and drives fine... motor puffs here and there. Battery is good... front tires are new with nubs still. Fluids all fresh... im throwing in a good used Kohler Magnum 8 originally off a 308 Wheel Horse. $400 is my break even number after hauling it there originally and now hauling it back. Take it home... finish the paint and decals and have a really nice 308 to mow and plow with (plows are easy to find...) . I was doing him a favor and think its worth the $400 espescially come spring mowing season. Thanks Tony 860-978-9039 

01/09/21

Relisted and this is the description I used--- the 42" plow will he swapped for a 48". So... above description and this one describes it 100%. 

Wheel Horse 308-8 with Kohler Magnum 8, 48" snow plow (the one in pic is 42" it will be swapped) weights, chains (not installed but included) and a 37" deck. I was bored yesterday and started the heater in my garage... next thing I knew I brought this inside, pulled off deck, added plow and weights. Then cleaned carb and fuel system and changed the oil in motor and transaxle. It runs good... plows good, cuts good. It's a solid little worker. Front tires are new with nubs still on them. Located in Andover CT 06232 delivery within reason for gas money and a burger is available. Tony (Ate Syx Oh) Nyne Sevin Ate Nyne Oh Tree Nyne

Recent maintenance: replaced the plugs this summer, fluids as needed (hydro has about 100 hours on fluid/filter; oil was done in the spring and has about 25 hours on it).  Battery is about 3 years old as are the tires, Terra Trac tires on the rear and turfs on the front.  The seat (with arm rests) isn't in great shape.  I've got a cover for the seat, never used.  It's never really bothered me but new seat cover is included in sale as are 4 hub caps, chains for the rear tires, and some misc spare parts (see photos).  

I've owed this machine about 8 year and put ~350 hours on her.  She's not a show piece but could be restored.  Sheet metal is generally in shape, no rust however the hood does have a couple dings in it.  

I'm only selling because I'm trying to help my son get a small lawn care business started and looking to move to a zero-turn.  The 60" deck is too large for our trailer, the mowing deck lacks pulley safety shields, and we'd like something that mows faster.  My only complaint with this machine is the top-speed (which isn't great when comparing to today's machines) otherwise she's a beast.  They don't make them like this anymore.  

Asking $150 for the tractor and mower deck. 

Also have a 48" plow for it if you wanted it as well with all the parts. Asking $200 for that.

I will do a bundled offer of $300 for both. 

PM for more information.  

The third photo is reproduction 520 hood decals and a couple tachmatic.  The 4th picture, (6 Danger decals) I'm not sure if they are NOS or not so I will assume repro.  $28 for picture 3 and 4, Including shipping.

Fifth photo is 45 repro hood decals. $28 including shipping. 

Please PM questions rather than ask in this thread. Thanks

There is some rust. There is wear and scratches. But it’s a pretty nice piece and not something you’ll easily find again. 
 

included is the 3.5” thick stack of well-used manuals.  They are stained and worn and some are deteriorated worse than others.  None of them are mint or in great condition.  Many are quite raunchy.   But they aren’t all stuck together or anything.   It actually looks pretty cool with its well-earned patina, I think.
 

It Covers a bunch of tractors and implements spanning up to about the late 1970’s or early 1980’s. I took pictures of random things in there to illustrate.  I saw an RJ dozer blade manual in there so it goes back quite a way.  It can be disassembled to add or remove manuals as you see fit. 
 

It’s probably not complete but that’s not the point.  It’s a neat item for your memorabilia setup.   This plus some of the other stuff I just listed will let you recreate a showroom if you’re so inclined.  
 

This will be shipped via UPS that you’ll pay for.  It’s probably 10 - 15 pounds.  CONUS only.   It will take me a day or two to find a box for it. 
 

$150/offer. PayPal or postal Money order.  

Kind of an oddball thing and I’ve not seen another.   $45/offer. Will be a pain in the butt to box up due to the size so don’t aim too low with your offers. 😊 
 

paypal or postal money order.  You pay UPS shipping. 

Nos 80s WH paint can, it's full but obviously not sure if paint would still be good-50$

Nos WH tape measure-50$

 Plus shipping on each if needed, PayPal friends option only plz