MalMac 1,212 #1 Posted April 16 On the K301 with the solid state igntion, what all does it take to switch back to points and condenser? I know of the obvious. It will take points, condenser, new coil, ignition switch. What else? Share this post Link to post Share on other sites
gwest_ca-(File Mod) 3,869 #2 Posted April 16 Bracket to mount the coil Points push rod Points cover and gasket Grommet for where the primary wire enters the points cover Mounting screws for cover and points Garry 3 Share this post Link to post Share on other sites
cafoose 685 #3 Posted April 16 Check out these threads : 1 Share this post Link to post Share on other sites
MalMac 1,212 #4 Posted April 16 cafoose, thank for the link. That’s what I was after. 2 Share this post Link to post Share on other sites
