"Manic-Mechanic" 1,192 #1 Posted March 24, 2018 Hello, I had a bad section of tailpipe and just cut some steel tubing just laying around the scrap pile. The tubing fit inside the ID of the factory pipe, however, the tact weld around the pipe never was completed! Hurry up and redo your work! Notice the black around the area! Da-hah! Oldman 1 Share this post Link to post Share on other sites
SylvanLakeWH 24,130 #2 Posted March 24, 2018 Friday afternoon...4:59 pm...Last one for the week...no one will notice... 2 Share this post Link to post Share on other sites
pfrederi 17,147 #3 Posted March 24, 2018 I have found a lot of WH factory welds that must have been done in a rush on Friday pm (or hung over on a Monday morning) 1 Share this post Link to post Share on other sites
"Manic-Mechanic" 1,192 #4 Posted March 24, 2018 (edited) permatex MTK-1 Spoiler too thin for me to try and run a bead! Lol Edited March 24, 2018 by Oldman Share this post Link to post Share on other sites
"Manic-Mechanic" 1,192 #5 Posted March 28, 2018 (edited) I found some "Tiger Tape", and then some good old clamps to help keep the tape in place until it melts into position, temporary until I change out the mufflers! Edited March 28, 2018 by Oldman 1 Share this post Link to post Share on other sites
SylvanLakeWH 24,130 #6 Posted March 28, 2018 AAAHHH!!! Thermal "Duct Tape"!!! I like it! 1 Share this post Link to post Share on other sites
