Jimmies1054 11 #1 Posted September 23, 2017 I can't seemed to find where I can buy new tie rods and ends for my 1054. Can some one post me the link please?? Share this post Link to post Share on other sites
AMC RULES 36,937 #2 Posted September 23, 2017 https://wheelhorsepartsandmore.com/steering.html#!/Steering/c/23548038/offset=12&sort=normal 3 Share this post Link to post Share on other sites
953 nut 51,018 #3 Posted September 23, 2017 Take a look here. https://www.wheelhorsepartsandmore.com/steering.html Seems Craig has a faster trigger finger than me! 2 2 Share this post Link to post Share on other sites
Jimmies1054 11 #5 Posted September 24, 2017 Thanks Fellas 1 Share this post Link to post Share on other sites
BOB ELLISON 2,976 #6 Posted September 24, 2017 The drag link has a 1/2-20 tie rod on one end and the other end is a 3/8-24 Here's a couple posts on 1054 1 Share this post Link to post Share on other sites
Aldon 4,826 #7 Posted September 24, 2017 Lowell, @wheelhorseman, carries a close substitute for the GT14 or at least did when I did my restore and I seem to recall same ball jointbthread pitches. I had to slightly drill out the spindle to accept it and it has held up fine and the steering is so easy it mimics power steering. Share this post Link to post Share on other sites
wheelhorseman 3,197 #8 Posted September 24, 2017 I do have them however they are not listed on my store yet - pm me if you need one 1 1 Share this post Link to post Share on other sites
Shynon 7,427 #9 Posted September 24, 2017 10 hours ago, wheelhorseman said: I do have them however they are not listed on my store yet Share this post Link to post Share on other sites
wheelhorseman 3,197 #10 Posted September 24, 2017 10 hours ago, wheelhorseman said: I do have them however they are not listed on my store yet - pm me if you need one 8 minutes ago, Shynon said: you're right that did sound a lot like somebody else that we know, I should have rephrased that statement 1 Share this post Link to post Share on other sites