Recently Browsing 0 members
No registered users viewing this page.
Can any one tell me what this is, other than just a Wheel Horse? The identification badging is missing, unless I am missing where it may be. The engine is a 14 horse Kohler, it is a hydro (both drive and deck lift), but other than that I am not sure about year/ model/ type of hydro drive/ if the hydro drive is one I can tap into for other hydraulic attachments such as lifts (3 point), etc...
Thank you in advance to all you WH guru's,
P.S.-Is there a good way to get the steering wheel off without breaking it as I have another good one on the machine next to it.
By Rob R
Have a C-81 with a 48" Snow Plow, the current Steel Bottom Scrapper Blade is on it's last season..... I have noticed as of late that quite a few folks are installing the POLY blades..... I plow a 100' macadam driveway and my concern and/or question is how well and how DURABLE are these blade. I did install feet on my existing steel blade plow (see pics) to limit the normal wear. Thanks for you input
So I have a 312 Wheel Horse. I have the Snow Blower attached and it was working great. I was using it last night when all of a sudden I heard a bang up near the the blower. I quickly disengaged the PTO lifter the blower and backed up to see if I had hit something. After inspecting i found that i did not hit anything. So I started clearing out any snow I realized nothing was stuck and the shear pins were still good. The augers had the normal amount of play. So I fired it back up and tried to engage the pto again it kind of bogged down and stalled out the engine almost. So I drove it to where i had better light. I could not see anything wrong still so I decided to try to engage it one more time to see if I could see anything. Well it started throwing so I decided to test it out and it worked fine. Then as I was going along it just stopped throwing again. So I don't know what it is. I plan on taking a look at the gearbox when I get home to make sure that's all set. Just thought I would check to see if any of you have suggestions of what I could check.
Hi a new member from Australia here.
I have owned... dare i say it a 14-38HXL for years... the hydro has just about quit so after much searching i went finally found a 244-5!!!!! I love this thing but its had a hard life, its built to last and I can tinker with it. It has a 42" deck that needs some work but that will come with time.
Finally got the engine going but I have some questions re trans/Clutch and Engine:).
This may seem like a stupid question but should I be able to move the crankshaft vertically? The engine runs but vibrates a lot? There is some horisontal movement in the shaft as well but I figure that may just be a lower bearing as I think that a previous owner bolted the electric clutch together and was starting the mower with the blade clutch engaged.
I welcome any thoughts:)