Jump to content
Gunman64

416 has trouble turning over

Recommended Posts

Gunman64

I have a 416 with a Onan engine, I noticed when i turn the key I hear a click but starter doesnt turn over. I have to turn key 4 or 5 times to get it to start, thats with or with out battery charger/starter hooked up. I think relay or could it be the starter?

Share this post


Link to post
Share on other sites
 
gwest_ca

These diagrams will have one for the starter circuit

One of these should have you covered.

 

Garry

  • Like 2

Share this post


Link to post
Share on other sites
 
JPWH

I would clean all terminals as a starting.point. then check for a bad component if that doesn't fix the problem.

  • Like 2

Share this post


Link to post
Share on other sites
 
953 nut

With any electrical problem the first step is to clean inspect and tighten ALL electrical connections including grounds. If the problem persists have the battery load tested.

  • Like 2

Share this post


Link to post
Share on other sites
 
squonk

The little wire terminal that connects to the solenoid is pretty crappy. That's a good place to check and clean. The opposite end of that wire at the relay is another corrosion magnet and was the cause of the same problem I had on my 520

  • Like 2

Share this post


Link to post
Share on other sites
 
Gunman64

Thanks all for the help, i will clean all connections and go from there. I will check back in after i do it.

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...