swisstrac 49 #1 Posted March 28, 2017 would appreciate info on thightning center mower mandrell ? can it be adjusted and if so how to proceed. its only the center one that needs attention, thank you much for help 1 Share this post Link to post Share on other sites
953 nut 51,008 #2 Posted March 28, 2017 One of these manuals should help you out. 1 Share this post Link to post Share on other sites
gwest_ca-(File Mod) 10,441 #3 Posted March 28, 2017 Trying something new here. Not much service info available for mower decks but just added a page from a spindle ID file that may help. The original spindle assembly for the 5-0481 mower deck is identified by a J. The others on the page were replacements available as improvements were made so any one of them could show up on a deck. When this link takes you to the file click on the screen shots that show up. It will enlarge so it is readable. Let me know if you think this would be useful. Garry 2 Share this post Link to post Share on other sites
gwest_ca-(File Mod) 10,441 #4 Posted March 29, 2017 Added a screen shot of the most recent Z spindle assembly since it is mentioned on the J page. Garry Share this post Link to post Share on other sites
swisstrac 49 #5 Posted March 29, 2017 thank you much Richard Gary and and good friend Aldon for all the info and manual for the sd mower 51482/ it looks to me like the slack can be taken up, therefore compressing the 2 bearings/ ?? ray Share this post Link to post Share on other sites