TIGman 2,006 #1 Posted October 27, 2016 (edited) The original gas tank on the Allis Chalmers BIG TEN is in sad shape. Many pin holes and it had already been coated inside sometime in it's lifetime. So I found some stainless steel plate from an old job and after a little bit of TIG welding I have a replacement till an original replacement tank can be found. Edited October 27, 2016 by TIGman 10 Share this post Link to post Share on other sites
SylvanLakeWH 24,104 #2 Posted October 27, 2016 Nice! 1 Share this post Link to post Share on other sites
Jerry77 1,218 #3 Posted October 28, 2016 Nice engine turning... 1 Share this post Link to post Share on other sites
Achto 26,537 #4 Posted October 28, 2016 Umm, I wouldn't want to replace that one, not even with an original. Great job! 4 Share this post Link to post Share on other sites
benji756 341 #5 Posted October 28, 2016 very nice work there 2 Share this post Link to post Share on other sites
roadapples 6,981 #6 Posted October 28, 2016 Really nice work... 2 Share this post Link to post Share on other sites
Fun Engineer 859 #7 Posted October 28, 2016 Nice work. 1 Share this post Link to post Share on other sites
WHX?? 46,723 #8 Posted October 28, 2016 11 hours ago, achto said: Umm, I wouldn't want to replace that one, not even with an original. Great job! 2 Share this post Link to post Share on other sites
wallfish 15,918 #9 Posted October 28, 2016 VERY NICE!!!! Wish I could weld like that. That inspires to get a TIG and take some classes. 3 Share this post Link to post Share on other sites
TIGman 2,006 #10 Posted October 28, 2016 Like I told my Granddaughter who I taught to weld, practice, practice, practice. She is a pretty good welder herself. 2 Share this post Link to post Share on other sites