Thread size of points cover screws

[Aldon 4,826]

I am adding a set of points to engine which previously did not have them. 

 

Anyone know the screw size to attach the points and the cover. Apparently they are same.

 

thanks!

[rmaynard 14,854]

Should be 10-24 x 3/8

 

 

 

 

 

 

Edited July 1, 2016 by rmaynard

[Aldon 4,826]

1 minute ago, rmaynard said:

Should be 10-32. If not, then 10-24. I have seen both.

 

Thanks Bob!

[rmaynard 14,854]

Just checked my  K241 and it is 10-24.

[rmaynard 14,854]

Just checked my  K241 and it is 10-24.

[Aldon 4,826]

I'll grab a few of each tomorrow morning from the hardware store.

 

One of these days I'll just buy a box of each from McMaster Carr.

 

 

[gwest_ca-(File Mod) 10,474]

You may like the fillister head screws that take an Allen wrench but often hard to find for this application. They don't get dropped so often.

https://www.google.ca/search?q=fillister+head&espv=2&biw=1680&bih=949&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwju387WztTNAhXI5oMKHRjaDXEQsAQINg&dpr=1

 

Garry

[pacer 3,159]

 

5 hours ago, gwest_ca said:

You may like the fillister head screws that take an Allen wrench but often hard to find for this application. They don't get dropped so often.

 

Amen to that!! I've got to where I hate those dang straight blade screws. When possible I change them out with socket head or second choice is go to philips head.

[rmaynard 14,854]

7 hours ago, gwest_ca said:

You may like the fillister head screws that take an Allen wrench but often hard to find for this application.

 

Tough to get the slotted head ones out with a Nelson muffler on a K241/301/321.