Jump to content
  • ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoticons maximum are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Similar Content

    • By IthacaJeff
      Hi folks:
      The wheel bearings in one of the front wheels of my 416-8 imploded the other day while mowing. 32 years old, I'm not complaining. Anyway, with the advice of another thread I picked up a set of 4 flanged bearings off an ebay seller. . .3/4" ID, 1 3/8" OD. Problem is they are a loose fit in the wheel hub. I should need to tap them in, but they just slide in and out. No real play, but they can just fall out. The insides of the hubs are clearly worn.  Any advice on snugging up the bearings"
       
      Thanks,
      J
    • By Team70R
      I have to pulleys available from a 42” deck. These are the 2 outer pulleys. $25 each shipped or $40 for the pair. Can send pics via text. 
    • By jerryme
      Hi everyone I'm looking for the center/drive spindle assembly with double pulley for my 1985 36" rear discharge wh mower deck. The only #'s  I have are off the mower deck. 85-6MR01-08150   8038. Any help is greatly appreciated. Thanks
    • By porschpow
      Good Morning everybody!
       
      I am in the process of sharpening the blades for my mowing deck (Model 78360 - Serial 7904987) and I noticed that the deck has a crack in it right where the bracket to the mounting hardware (to the tractor) is. SO I know I have to get that repaired.
       
      But while I was at this, I thought I could do a good quick once over on the deck to make sure I am ready for the season.
      What I would like to do is the following:
      Change the bearings for the spindles (or pack them with more grease)
      Get new rear tires (since they squeak)
      And that's about it
       
      If anyone here thinks I should do anything else, I would love to hear it!
       
      Where does everyone get the hardware (bearings, wheels for these rebuilds?)

    • By Bill Sherman
      I have a 1977 C-120 eight speed.  According to the number on the mower deck (05 42MS05) it is a 1986 model year.  Where can I find a parts diagram so I can get part numbers?  I need to replace the pulleys and I want to make sure I order the right ones.
×