dusted800 1 #1 Posted November 26, 2008 Hi: am looking at a rototiller for my D tractor but the tiller is missing half of the driveshaft. Is this something that is standard O category and can be gotten anywhere or is it a Wheel Horse part. Thanx. wnk. Share this post Link to post Share on other sites
Jim_M 178 #2 Posted November 26, 2008 Hi, It's not a standard pto shaft. It was specific to the D 160, 180 and 200 Wheel Horses. Somebody told me once that John Deere used the same pto coupler on some models, but I don't know what models, what years or if it's even true, I never checked it out. Good luck. Jim Share this post Link to post Share on other sites
pond195520032003 27 #3 Posted November 26, 2008 the drive shafts are hard to find without the tiller and are pricey :hide: Share this post Link to post Share on other sites
68charger 0 #4 Posted September 12, 2023 (edited) Yes I am looking for the infeed spline shaft that goes into the tiller, 36 spline I believe. The part on the end inside of the tiller broke off letting the snap ring to come off which let it come out and everything that was on the shaft including the bevle gear all inded up in the bottom of the gearbox!! So I am desperately trying to locate that shaft, part number 100882 , If any one knows where to find one please let me know, thanks Justin. Tiller model number is 7- 1260. Edited September 12, 2023 by 68charger Left out the model number of my tiller. Share this post Link to post Share on other sites