jake22si 5 #1 Posted November 15, 2008 Can you rebuild a Kohler fuel pump or should I just buy a new one :hide: Share this post Link to post Share on other sites
illinilefttackle 399 #2 Posted November 15, 2008 Jake-I don't think the rebuild kits are still available. I got mine from NAPA at a reasonable price. They can look it up by application in their Small Engine Cataloge. AL Share this post Link to post Share on other sites
sorekiwi 761 #3 Posted November 15, 2008 I dont think the kits have been available for a few years now. But since you have nothing to lose, you may as well pull it apart and see whats wrong - make sure there's no crap stuck in the check valves. I've successfully stopped a couple leaking by lapping the pump halves on some 600 grit wet and dry on a piece of glass. Be prepared for a shock when you price a new one.... Share this post Link to post Share on other sites
glenn27 64 #4 Posted November 15, 2008 Right on the $$$ shock! and it will be poly plastic--with new 'pop-in poly nipples... Share this post Link to post Share on other sites
jerrell 1 #5 Posted November 15, 2008 :hide: Could you not use an electric fuel pump, i had to buy one not to long ago and you could get one that pumps with very little pressure, I didn't know this until i had to buy one. they make them to pump any pressure. :D Share this post Link to post Share on other sites
jake22si 5 #6 Posted November 16, 2008 I took it apart and cleaned it out and now it works. Good thing I didn't Buy one! :horseplay: :banana: :hide: Share this post Link to post Share on other sites
sorekiwi 761 #7 Posted November 16, 2008 and it will be poly plastic--with new 'pop-in poly nipples... I got nothing against poly nipples and silicone! :hide: Share this post Link to post Share on other sites
linen beige 14 #8 Posted November 16, 2008 I got nothing against poly nipples and silicone! I prefer the ones that pop out. Glad you got her goin' again! :hide: Share this post Link to post Share on other sites
Greg Parnell 6 #9 Posted November 30, 2008 Is the fuel pressure on a a K161 about 2 to 3.5psi? Share this post Link to post Share on other sites
BairleaFarm 339 #10 Posted December 2, 2008 Other than the diaphragm what wears out in the pumps? is the shaft connected to the diaphragm? wonder if a rebuild kit could be made? Share this post Link to post Share on other sites
