Woodsie 51 #1 Posted December 29, 2014 Anybody use a Harbor Freight V-Twin 22HP to replace an Onan P220 that canibalized the valve seat? I know the shaft is smaller in diameter but I have a good friend machinist. Share this post Link to post Share on other sites
Woodsie 51 #2 Posted December 31, 2014 Is nobody answering because its been on this forum before? Any answer would be appreciated. Share this post Link to post Share on other sites
fireman 1,021 #3 Posted December 31, 2014 There is a thread about this engine already somewhere on the site. The search engine at the top of the page is your friend. Share this post Link to post Share on other sites
woodchuckfarmer 333 #4 Posted January 1, 2015 I had 2 seats replaced . It cost me $138 at an engine shop. Wayne Share this post Link to post Share on other sites
Woodsie 51 #5 Posted January 1, 2015 Whoa i checked a local here, they wanted $200 / side! Share this post Link to post Share on other sites
woodchuckfarmer 333 #6 Posted January 1, 2015 They were done at Harries in Sayre Pa. Share this post Link to post Share on other sites
Woodsie 51 #7 Posted January 3, 2015 yeah i am 30 miles east of Pittsburgh. thats almost a 5 hr ride. anybody know any shops to do those seats near Pittsburgh? Share this post Link to post Share on other sites