meadowfield 2,545 #1 Posted October 21, 2014 I bought a C-161 to part for the engine a few years back which is a runner, but the PO welded the pipe nipple into the block and i just don't like that So I picked up an M16 which looks in very good condition, but has a lot of hours on.... My Raider will be getting a 16hp transplant and in trying to keep it looking authentic I'm thinking of swapping tin work on the engines, so will K341 tinwork fit an M16 and vice versa? thanks Share this post Link to post Share on other sites
can whlvr 991 #2 Posted October 22, 2014 (edited) im not a hundred percent sure but I don't think they are the same,the starter is different and that makes the bearing plate di Edited October 22, 2014 by can whlvr Share this post Link to post Share on other sites
meadowfield 2,545 #3 Posted October 22, 2014 ahh, the starter is different - and I'm guessing the flywheel too? Share this post Link to post Share on other sites
Fordiesel69 188 #4 Posted October 22, 2014 Different, and the blocks do not have points provision. Share this post Link to post Share on other sites
Forest Road 593 #5 Posted October 24, 2014 Drill a few holes in K series cowl and it should fit. You won't have points. Share this post Link to post Share on other sites