wake49 18 #26 Posted October 22, 2014 I don't know if I have a small sledge home. I will have to check. Think a 16 oz framing hammer will work? Share this post Link to post Share on other sites
pacer 3,159 #27 Posted October 22, 2014 Think a 16 oz framing hammer will work? Sure, I think it'll do better than the dead blow.... Share this post Link to post Share on other sites
pfrederi 17,120 #28 Posted October 22, 2014 If the relatively soft woodruff key is damaging your chisel, I think I would not buy that brand of chisel again. 1 Share this post Link to post Share on other sites
wake49 18 #29 Posted October 22, 2014 It was an old, crummy chisel anyway. I was more surprised at how relentless this key is! Share this post Link to post Share on other sites
wake49 18 #30 Posted October 27, 2014 Ok. It is out! I drilled three holes down into the key, shot some PB down in there, and when I tapped on it (with a four pound sledge) from the wheel end it bent up and out of the keyway. It took everything I had yesterday (about an hour and a half), so I will work on the seals later this week. 2 Share this post Link to post Share on other sites
pacer 3,159 #31 Posted October 27, 2014 I tapped on it (with a four pound sledge) "tapped" with a 4 pound sledge --I like it. It really amazing how something like this can turn into such an ordeal, glad you got it out... Share this post Link to post Share on other sites
JERSEYHAWG / Glenn 4,487 #32 Posted October 27, 2014 Wake,,,, finally,,,,,,celebration. Miller time. Rockets and flares shoot into the sky. Sigh of relief. Ok, on to the next phase. Glenn Share this post Link to post Share on other sites
