Jump to content
Sign in to follow this  
illinilefttackle

A-81 Rear Engine Mower

Recommended Posts

illinilefttackle

Hey Guys- anyone got a pic or dimensions for the crankshaft pulley on an A-81 ? Or better yet- does anyone have one they would part with? I'm trying to complete an A-81 to sell and need that pulley-Thanks-Al

post-132-0-36553600-1372084244.jpg

Share this post


Link to post
Share on other sites
 
groundhog47

PM'd about classified, thought you had gotten A-111 sometime back, but was someone else. Will post a picture in a 10 or 20 min break. Attached NOS parts except manual: 1st pic (L) = engine pulley, 108286, ® = clutch, 106565 below (L) red + clutch engagement bar and brake, 108535 small cylinder is clutch shaft, 108431, white roller is cable roller for deck, 106474, same as on some of the front eng mods. May have the clutch and brake springs, haven't thoroughly researched other stuff   Do not have race, needle bearing, roller bearing, prob have snap rings  

post-8388-0-93716600-1372386200.jpg

post-8388-0-29725200-1372386221.jpg

post-8388-0-78336900-1372386240.jpg

post-8388-0-17267700-1372388198.jpg

post-8388-0-26024600-1372388212.jpg

Edited by groundhog47

Share this post


Link to post
Share on other sites
 
groundhog47

Hey Guys- anyone got a pic or dimensions for the crankshaft pulley on an A-81 ? Or better yet- does anyone have one they would part with? I'm trying to complete an A-81 to sell and need that pulley-Thanks-Al

Lever at left = mower engagement that pulls up red bar, holding clutch drum, into engine pulley. Could you post a close up of complete top of deck and any extra parts that came with unit. I will try enlargement of photobucket.

Share this post


Link to post
Share on other sites
 
illinilefttackle
Talk about bumping into a post LATE- I finished the A-81 that was mentioned in this post-turned out OK. BUT- I had another one donated to me to complete & help my Foster Son/ Grandson with his expenses. It is an earlier one using the Cones you have pictured- thanks for posting the pictures & info- I am now in need of these parts-the two piece pulley & cone PTO, I have the arm & other parts- Do you still have access to these parts? Thanks for any help you may give.- Al
 

post-8388-0-29725200-1372386221.jpg

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...