Jump to content
  • ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoticons maximum are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Similar Content

    • By 'garGuyPaulie
      Hello all - I have a 1990 312-8 that recently started being a pain to shift, and eventually it stopped shifting into 1st and reverse and was hard to get into 2nd and 3rd. After looking at some posts on here I discovered the possibility that a loose shifter could cause this problem. My shifter definitely had a lot of play in it so I proceeded to pull the seat, rear plate and shift plate off the tractor so I could get to the area where the shifter goes into the transmission. I removed the shifter, reseated it and got the dog head screw lined up in the shifter donut and was hoping that would fix the issue, but after getting it all reassembled and trying to shift even into 2nd or 3rd the shifter, while not as sloppy, now just turns side to side - taking it back out and inspecting the shifter I have discovered that the pin which holds the donut in place on the shifter has sheered and the donut is now able to free spin on the shaft. Not too much of a problem as I plan on just pressing the old pin out and replacing, however I am concerned that the ball on the end of the shifter seems to be getting pretty flattened off on the left and right sides of the ball. I tried looking up a replacement on Toro and several other parts websites but I can't find one anywhere - I can get the boot, everyone has those, but no shifter. My question is, does anyone know where I might be able to find a new shifter and more important, is a little flattening on the ball anything to worry about? 
       
      Also, with the shifter out, looking down the hole my transmission looks like it's full of mud! Definitely doesn't look like the gear oil I put in it - anyone know what could be causing the transmission gear oil to be sludging up like that? 
    • By drewd
      Hi, I found a 200 series RD 36" mower (05-36XR01-11097) in really great shape. It was from a vertical shaft mower and had the mower drive belt guide towards the rear as a separate unit (not on the front spindle). I am trying to convert it to use on my 1972 Commando.  The spindles are have round shafts with grease fittings.   The spindle shafts look long enough to use the double belt pulley on the front spindle.  Can you still buy the double belt pulleys that will fit on these round spindle shafts?  Any suggestions are greatly appreciated!  I have two double belt pulleys from old decks but the are for the shafts with two flat sides!
    • By mikeystones
      Has anyone tried to link two trans. Together 
    • By Rkeller
      Can anybody help with a bearing kit for asundstran hydro trans tag # 90.  1137 on a d180 
    • By Rkeller
      Can any body  help me find a bearing kit for asundstran  hyro trans tag # 90 1137.   Need intermediate  shaft   bearing that is mounted in case
×