EdG. 5 #1 Posted October 22, 2011 Got a 1969 Electro 12 and a 6-7111 doser blade. I made a lift arm that was 9.25" long between the center of the pins. But when I lift the blade the blade frame hits my front axle. I think I may have made my lift arm too short. (??) Red Square was down so long I didn't have a chance to ask earlier. Does anyone know what the correct length between pin centers should be for my application? Share this post Link to post Share on other sites
KB9LOR 4 #2 Posted October 22, 2011 Got a 1969 Electro 12 and a 6-7111 doser blade. I made a lift arm that was 9.25" long between the center of the pins. But when I lift the blade the blade frame hits my front axle. I think I may have made my lift arm too short. (??) Red Square was down so long I didn't have a chance to ask earlier. Does anyone know what the correct length between pin centers should be for my application? Ed, I got one that was on that plow you have, let me know if you want it. I sent you a PM explaining. Give me a call tomorrow if you still have my number. Share this post Link to post Share on other sites
EdG. 5 #3 Posted October 22, 2011 Brian, sent you a PM, thanks! Ed Share this post Link to post Share on other sites
can whlvr 991 #4 Posted October 23, 2011 without going out tonight i think it was 11and 1/4 inches center to center hole Share this post Link to post Share on other sites