Jump to content
Sign in to follow this  
312horse

seal

Recommended Posts

312horse

I appear to be losing my gear lube out of my 312-8 tranny from around the shaft that holds the brake drum , where do i get that seal , and also is that just dug out of around the shaft and the new one put back in from the outside ? :woohoo:

Share this post


Link to post
Share on other sites
 
 
Mike in Esko

If it is more convenient for you, I've just gone to NAPA and picked up the seals/bearings that I've needed. My axle shaft seal was leaking and I damaged the needle bearing digging out the seal and it cost me $15 at NAPA for the replacements.

Share this post


Link to post
Share on other sites
 
jpmcleod

I took my old seal to NAPA and bought an "O" ring seal the same size. Mine stopped leaking.

I drilled a very small hole in my seal and popped it out with a punch. I was very carefull not to drill into the casing by turning the bit at a 45degree angle so it would not bite into the casing. Came out easy. Good luck.

Share this post


Link to post
Share on other sites
 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...