k-241 belt length

[yokomist 0]

Hey guys, does anyone know the length of the starter/generator belt off a k-241?

I need a quick replacement and was hoping to get something temp from TSC.

Any ideas?

Thanks

Bevan

[Retired Wrencher 4,876]

:) Hi Bevan I just bought a shop manual = hard cover not paper back and there is to Meany to list. For my 1075 I will go to dealer and have them measure it. I am not kidding there is a bunch of choices here to save time and aggravation I would go to a good dealer have them measure for length. if the old one is next to the gas tank 1" shorter. Gary B..

[yokomist 0]

Thanks Gary,

Mine disintergrated unfortunatley and blew into a million pieces!

I will just have to try a couple out I guess.

Thanks for taking the time to reply,

Bevan

[TT-(Moderator) 1,127]

# 3L350 or equivalent

[Retired Wrencher 4,876]

:) I can take a picture if needed of the page but I am sure TT is not far off Just let me know if u would like me to do this. Gary B.............

[daemon2525 5]

I have three old ones hanging in the garage and they measure 33.5 34 and 34.5

with a tape measure around the "outside"

Sorry, I am no help....

Oh, yea, They are kinda skinny so they are surely 3/8 rather than 1/2"

[yokomist 0]

Thanks for the replies everyone,

Just to follow up, if someone needs a quick replacement from TSC around 36" should be good.

I got a 34" but its just a touch too small to go on.

Thanks

Bevan

[TT-(Moderator) 1,127]

A 3L350 would be 3/8" wide by 35" long. (outside or top measurement) :)