dusted800 1 #1 Posted July 19, 2009 picked up an old snow plow for my B80 the other day but it was missing the angle adjustment rod. Never paid much attention to them so maybe you guys can answer a few questions. at the end that goes into the plow head, is that just bent up to go into the hole with a cotter pin? Is the handle end got some adjustment on it. and can someone tell me how long it is and a picture would be great!!! thanx. lwnk. Share this post Link to post Share on other sites
TT-(Moderator) 1,127 #3 Posted July 21, 2009 I hope this is the rod you're talking about: The front of the rod is bent up @ 90 degrees and is held in place by a cotter pin or hitch pin clip up inside the sector weldment. As far of the length of the rod goes.... measure the distance between the holes when the blade is straight and the lower part of the handle (from the pivot bolt to the bottom) is at 90 degrees to the A frame. (straight down) Share this post Link to post Share on other sites
dusted800 1 #4 Posted July 21, 2009 thanx TT thats exactly what I was looking for, wnk Share this post Link to post Share on other sites