Jump to content

boomers_influence

Members
  • Content count

    156
  • Joined

  • Last visited

Community Reputation

86 Excellent

4 Followers

About boomers_influence

  • Rank
    Advanced Member

Wheel Horse Information

  • favoritemodel
    520H

Profile Information

  • Location
    hastings mn 55033

Recent Profile Visitors

2,449 profile views
  1. onan crank trigger

    96W there is an ignition control, ( module ) and an ignition rotor.( on the crank ) which did you replace? thank you. boomer ( the used onan engine parts guy, also NOS and new )
  2. 520 H Nikki carb expert?

    seacher60 and club there are NO instructions for the emissions carbs.( 146- 0697,0698,0699 and 0700 ) they DO NOT want us to work on them. ( i do stock the accel pump kit ) the 146-0698 has a # 238 venturi and a # 122 main jet. the prior carb for the P 220 is the 146-0414 and the 146-0479. both of the above have a # 238 venturi and a # 134 main jet. for TEST PURPOSES i could sell you a NON emissions carb. boomers_influence@yahoo.com thank you. boomer ( the used onan engine parts guy, also NOS and new )
  3. Onan p220 performer crankshaft differences

    erustic the pic tells it all. the sears engine is a 10896 B ( information from the bottom of the tag ) the WH is 10540 B both have the 45 BB crank. ( 1 1/8" X 2.74" usable length ) thank you. boomer
  4. Onan p220 performer crankshaft differences

    erustic the sears # means NOTHING. i need the actual onan # from the sears. thank you. boomer
  5. Onan p220 performer crankshaft differences

    erustic please post the spec # from both engines. i should be able to to tell you if they are the same. thank you. boomer ( the used onan engine parts guy, also NOS and new )
  6. Valves

    bob YES, i do have them in stock. boomers_influence@ yahoo.com 651 437 2826 M-F 10-7 S-S 12-6 cent time. thank you. boomer ( the used onan engine parts guy, also NOS and new )
  7. Starter Pinion gear not contacting flywheel correctly

    lablan please list the 191-xxxx-xx # of the NEW starter. as viewed from the rear there are only 3 P starters. one with NO solenoid. one with the solenoid at 3 O clock one with the solenoid at 6 O clock thank you. boomer ( the used onan engine parts guy, also NOS and new )
  8. Conversion of Onan P216G to P220G

    outback if both engines are new, here are the differences. ( 16-20 ) crank, rods, cam and carb. 16 to 18 is only crank and rods. thank you. boomer ( the used onan engine parts guy, also NOS and new )
  9. Onan p220 help!!

    boostedtoy you do not state the coil # that you have?? the coil # will start with 166-0xxx. the replacement coil has different resistance values. AS A RULE, surging = to much air, or not enough fuel. you stated you cleaned the carb, did you remove it to clean it? did you remove the main jet and the idle jet tube to clean them? did you check the float level setting? did you check to see if the welch plug is in place at the rear of the carb? did you check the volume of the fuel pump output? thank you. boomer ( the used onan engine parts guy, also NOS and new )
  10. 518 repower with briggs vanguard 16 horse

    littleredrider and club FYI your P 218 is 47.7 CID the 16 vanguard is 29.2 CID can you say TORQUE? thank you. boomer ( the used onan engine parts guy, also NOS and new )
  11. 520H starter motor

    tbird the starter # is 191-1949-04. 191-1808-04 is the prior # thank you. boomer ( the used onan engine parts guy,also NOS and new)
  12. 50 inch Tiller Parts

    brett i do have a NOS DD-16 carb in stock. ( NEW OLD STOCK ) boomers_influence@yahoo.com 651 437 2826 M-F 10-7 S-S 12-6 cent time. thank you. boomer ( the used onan engine parts guy, also NOS and new )
  13. Onan p220 head gasket

    tom if i understand you correctly, you are saying you have oil inside the air cleaner housing. this WOULD NOT, be from a blown head gasket. it most likely be from EXCESSIVE crankcase pressure, it is time to do a compression and leak down test. boomers_influence@yahoo.com 651 437 2826 M-F 10-7 S-S 12-6 cent time. thank you. boomer ( the used onan engine parts guy, also NOS and new )
  14. Coil

    sarge is this perhaps an onan engine? if so it will have the onan # 166-0xxx on it. boomers_influence@yahoo.com thank you. boomer ( the used onan engine parts guy, also NOS and new )
  15. P220 Heads and intake installation

    raz i have always used a lite coat of anti sieze on the head bolts, BUT, i stay on the low side of the torque spec. thank you. boomer ( the used onan engine parts guy, also NOS and new )
×